Iec 60269

The removable part of the fuse holder has a small window to allow inspection of the indicator without removal of the fuse. The application category is a two-digit code. These fuses are larger and have higher ratings than the screw type fuses, exceeding kA.

International Electrotechnical Commission. Traditional diazed fuse holders are made as a conducting metal envelope covered with non-conducting porcelain cover. North American standards call the replaceable element only the fuse. Edit my profile Access my dashboard.

IEC Webstore
IEC - Howling Pixel

Navigation menu

General and safety requirements. For the Neozed fuses, there are also fuse bases with integrated disconnecting switches. In electronics and electrical engineering, a fuse is an electrical safety device that operates to provide overcurrent protection of an electrical circuit.

Do you need a multi-user copy? Gauge rings are intended to be changed only by authorized personnel. The fixed part of the fuse holder contains a usually colour-coded gauge ring, which will accept end caps up to a certain diameter. Look inside Relevant for rural electrification. Functional safety of electrical, hey baby i love you ringtone electronic and programmable electronic control systems.

From Wikipedia, the free encyclopedia. Wiring regulations usually define a maximum fuse current rating for particular circuits.

The time and current operating characteristics of fuses are chosen to provide adequate protection without needless interruption. It may happen if a fuse holder was accidentally dropped or someone was using too much force to screw it in.

Navigation menu

This edition constitutes a technical revision. With new versions of these load disconnecting switches, the fuse cartridges are no longer screwed, but are held by spring clips.

Images, videos and audio are available under their respective licenses. Fuses have been used as essential safety devices from the early days of electrical engineering. Changing fuses with the circuit off increases the safety of the user. Its essential component is a metal wire or strip that melts when too much current flows through it, thereby interrupting the current. Guide to the measurement of the static thrust applied to brushes.

Rural electrification

IEC - Howling Pixel

Under mechanical stress it is possible for the cover to crack partially or fully, uncovering the conducting element. This page is based on a Wikipedia article written by authors here. The indicator button usually has a coloured dot indicating the fuse rating see table. Uncovered metal envelopes present a serious risk of shock and should be replaced immediately under extreme precautions by trained personnel.

List of International Electrotechnical Commission standards. The size of the gauge ring is determined by the current rating of the circuit to be protected. It is therefore not possible to fit a fuse of a higher rating than allowed for by the gauge ring. Log in Username Password Forgot your password?

Fuses of the same application category can be substituted for each other provided the voltage rating of the circuit does not exceed the fuse rating. An isolation protection mat and isolating gloves may be necessary. Supplementary requirements for fuses for use by authorized persons fuses mainly for industrial application - Examples of standardized systems of fuses A to K. When the fuse blows, the wire breaks and the indicator button is ejected by the spring.

IEC Standard - Home

IEC System of Conformity Assessment Schemes